Electrical Installation; Connecting The Boundary Cable To The Base Station; Connecting The Low-Voltage Cables To The Transformer - Brill Roboline R30 Originalbetriebsanleitung

en
19

Electrical Installation

19.1

Connecting the boundary cable to the base station

1. Remove the insulation from the boundary cable (2) after laying the cable and connect to the spring ter-
minals (1).
19.2

Connecting the low-voltage cables to the transformer

1
2
3
1. Strip 10 mm of insulation off the low-voltage cables (3 / 4).
2. Unscrew the screws with a screwdriver (2) and connect the low-voltage cables to the transformer (1).
The cables can be connected to either terminal, there is no need to observe a particular polarity.
3. Insert the mains plug of the transformer into the mains socket.
56
1
4
2
Betriebsanleitung
Roboline™ R30