Selecting The Menu; Program Menu - Brill Roboline R30 Originalbetriebsanleitung

en
1. Switch on the Roboline™ R30 by pressing the [ON/OFF key].
2. Enter PIN code,
The PIN code may also be the factory code if no different code was entered during calibration.
After the PIN code has been entered, the [Next mowing] information appears, or the current mowing
duration.
The displayed mowing operation may be the factory setting, unless a new mowing operation has
already been programmed.
Next use
Tues
Charge
The Roboline™ R30 is now ready for the programs and settings to be selected.
21.3

Selecting the menu

1
After switching on, it is possible to call up the main menu with the [menu key] (1).
21.4

Program menu

Description of function keys,
ADVICE
Make the settings in the week program.
Program the entry points.
Look at the program info, e.g. mowing program.
21.4.1 Selecting the program
Before programming, it is necessary to perform the start procedure,
Main menu
Programs
Settings
Back Confirm
1. Use the [up arrow key] or the [down arrow key] to select the [Pr o g r am s ] menu item.
2. Confirm with the [multifunction key right].
3. Select the required programs and confirm with the [display key right].
64
Enter PIN code, page 59.
Control panel, page 49
Betriebsanleitung
Starting the Roboline, page
Programs
Week program
Entry points
Back Confirm
Roboline™ R30
71.