Opening The Base Station; Checking The Connection - Brill Roboline R30 Originalbetriebsanleitung

Electrical Installation
19.3

Opening the base station

The cover only has to be opened for the purpose of checking the LED displays.
1. To check the connection, open the cover (2) on the rear of the base station (1).
2. Unscrew the fastening screws (3) and remove the cover from the base station.
19.4

Checking the connection

The LEDs must light up when the cables are connected. If this is not the case, pull out the mains plug and
check if all plug connections and cables are correctly seated; also check them for damage.
yellow LED (1)
lights up if the base station is connected to the transformer and there is an electrical power supply to
the transformer.
fl ashes when the Roboline™ R30 is charging.
green LED (2)
lights up when the boundary cable is laid correctly and the loop is OK.
fl ashes and then goes out if the loop of the boundary cable is not OK.
454 912_a
1 2
1
2
3
57