Oven In Use; 1- Switching On The Burners - Gastrodomus SPACE 4 Gebrauchs- Und Wartungsanleitung

7.2 – OVEN IN USE
THE OVEN CAN BE PUT IN USE ONLY AFTER COMPLETE INSTALLATION
WITH A WRITTEN DECLARATION FROM BOTH ELECTRICAL AND GAS
TECHNICIANS IN CONFORMATION TO THE ELECTRICAL AND GAS
CONNECTIONS.
Putting the oven in use can be carried out by an employee/operator respecting scrupulously
the following sequence of operations:
7.2.1 – SWITCHING ON THE BURNERS
1) Plug in the oven electrical connection to the electrical main supply
2) Rotate the knob of the interignition tab of the gas supply;
3) Press on the general electrical switch (FIG.14-Rif.6), the green lamp will light;
4) Set the thermostat/thermometer to the working temperature pressing the "set" and "+" or
"-" keys (FIG.14-Ref.1). In case the desired temperature is the some or below than the
atmospheric temperature it will be impossible to switch on the burners because the
thermostat is connected to the gas feeding electrovalve which stops the gas flow when the
temperature reaches the desired value.
A) INTERIGNITION BURNER
5) Rotate the knob of the general tap of the gas supply (FIG.14-Ref.4) to the position, press
and hold the knob and at the some time press repeatedly the piezoelectric ignition pilot
(FIG.14-Ref.5); release the knob should the pilot burner lights.
The pilot flame must remain lighted.
If it doeas not happen, repeat the operation.
It is possible to control the pilot flame through the loophole at the right side of the frontal
panel (FIG.3-Ref.2).
6) Rotate the general tap knob (FIG.14-Ref.4) to the position
USE AND FUNCTION
(maximum power);
25