Gastrodomus SPACE 4 Gebrauchs- Und Wartungsanleitung Seite 54

As stated above in regards to the adapting procedure, the appropriate
transformation stages are as follows:
A) Substitution of upper and lower burner nozzle:
Remove the front panel (FIG.3-Ref.2) unscrew the screws,remove the airregulator
(FIG.9-Ref.1/2), the nozzles are visible and can be reached. Loose the nozzle with a
suitable spanner and substitute them with adaptable types as shown in the technical
data according to the oven model.
B) Substitution of interignition burner nozzle:
Sobstite the interignition burner nozzlen (FIG.8-Ref.3) following the indication as
shown in the technical data according to the oven model.
C) Substitution of pilot nozzle:
Unscrew the pipe-fitting (FIG.8-Ref.4) and substitute the pilot nozzle with another
adaptable type, following the indications as shown in the technical data according to
the oven model.
D) Air regulation
Upper and lower burners:
Loose the screws (FIG.9-Ref.1) and regulate the air-burner (FIG.9-Ref.2).
After the air regulation fasten the screw in the right position (FIG.9-Ref.1).
E) Minimum regulation of upper and lower burners:
For liquid gas operation (G30 - G31) the minimum is fixed and the screw (FIG.10-
Ref.1) fastened ,for the use of other types of gas the minimum regulation is as
follows:
- Pull off manaully the respecvtive burner knob on the control panel (FIG.10-
Ref.2/3);
- Turn the screw (FIG.10-Ref.1) anticlockwise 2 or 3 times and then fix the
knob again;
-Switch on the burner and turn the knob in position (Minimum);
- Pull off again the knob and fasten the screw (FIG.10-Ref.1) until the lighted flame
is visibly acceptable;
- Make some turns of the knob (Maximum) (Minimum) to verify the stability of
the flame.
The interignition burner does not have minimum operation therefore there is no need
regulating it.
17
INSTALLATION