R911344640 / 01
|
Simulator PRC7000
3.3
Electrical connection
General information on damage to property and products
Incorrect voltage supply
Possibility of damage to the electrical equipment!
"
Check whether the supply voltage coincides with the nominal vol
tage indicated on the nameplate of the product!
The product may only connected to the mains if these values coin
cide.
"
Make sure that fluctuations or deviations of the supply voltage
from the nominal value always range within the permitted tole
rance limits (refer to technical data).
Plugging or unplugging modules or connectors/terminals into/from
live systems
Possibility of damage to the electrical equipment, unexpected
plant reactions!
"
Unless described otherwise, never unplug or plug any connec
tors/terminals on live systems.
"
The simulator power supply should always be disconnected be
fore inserting/removing any simulator modules.
Electrostatic charge
Possibility of damage to the electrical equipment!
"
Observe all precautions for ESD protection when handling modu
les and components and avoid electrostatic discharge.
"
Observe the following protective measures for modules and
components sensitive to electrostatic discharge (ESD):
• Personnel responsible for storage, transport, and handling
must have training in ESD protection.
• ESD-sensitive components must be stored and transported in
the prescribed protective packaging.
• ESD-sensitive components may only be handled at special
ESD workplaces.
• Personnel, working surfaces, as well as all equipment and
tools which may come into contact with ESD-sensitive
components must have the same potential (e.g. by groun
ding).
• Wear an approved grounding bracelet. The grounding bracelet
must be connected with the working surface through a cable
with an integrated 1 megaohm resistor.
• ESD-sensitive components may by no means come into con
tact with chargeable objects, including most plastic materials.
• When inserting or removing ESD in/from other devices, the de
vice must be safely disconnected from the supply.
Bosch Rexroth AG
NOTICE
151 / 256