Testing Of The Appliance; Adjustments - Angelo Po 0N0TPE Bedienhandbuch

Important
Install the equipotential terminal (included)
as shown in the image.
Check that the ignition plugs are working pro-
1)
perly and that the power supply cable is intact.
Place the equipotential terminal (A) under the
1)
equipment, next to the rating plate (C).
Attach it with two screws (B) directly to the ste-
2)
el base of the equipment, using the provided
holes.
Important
Before it is put into service, the system must
be tested to check the operating conditions
of every single component and identify any
malfunctions. In this stage, it is important to
check that all health and safety requirements
have been complied with in full.
To test the system, make the following checks:
Check that the mains voltage is the same as
1)
that of the appliance.
The appliance's main functions do not require
any special adjustments by specialist staff except
the settings made during use by the user.
The appliance's main functions do not requi-
re any special adjustments by specialist staff
except the settings made during use by the user.
3320120_inst_GB
EQUIPOTENTIAL TERMINAL INSTALLATION

TESTING OF THE APPLIANCE

ADJUSTMENTS

ADJUSTMENTS PROCEDURE
ADJUSTMENTS
ADJUSTMENTS PROCEDURE
C
A
B
Turn on the master switch to check the elec-
2)
trical connection.
Check that the safety device is operating
3)
correctly.
After testing, if necessary instruct the user in all
the skills necessary for putting the appliance
into operation in conditions of safety, in accor-
dance with legal requirements.
- 9 -
B
GB
ENGLISH