Safety Devices; Safety And Information Signs - Angelo Po 0N0TPE Bedienhandbuch

Although the appliance is complete with all sa-
fety devices, during installation and connection
additional devices must be added if necessary
to comply with the relevant legal requirements.
The illustration shows the position of the
devices.
Safety thermostat with automatic reset: cuts
A)
off the mains electricity supply to the plate
zone heating element in case of plate overhe-
ating. Once the problem has been resolved
and the temperature has returned to normal,
operation is automatically restored.
Important
There are no indicator devices to signal that
the thermostat with automatic reset has
been tripped.
Heat sensor: warns of overheating in the
B)
components compartment.
The illustration shows the position of the signs
provided.
Nameplate with manufacturer and
A)
appliance data.
General hazard:read the manual carefully
B)
before carrying out any procedure.
General hazard: when washing the applian-
C)
ce do not point pressurised water jets at
internal parts.
General hazard: all relevant regulations
D)
must be complied with. "Install in complian-
ce with the relevant regulations and use in
well ventilated premises only".
General hazard: all relevant regulations
E)
must be complied with. "No liability is ac-
cepted in case of failure to comply with the
installation and commissioning instructions".
General hazard: watch out for hot surfaces.
F)
CE marking: indicates that the appliance is
G)
compliant with the relevant norms.
3320120_ut_GB

SAFETY DEVICES

SAFETY AND INFORMATION SIGNS

- 5 -
A
A
E
ПРОИЗВОДИТЕЛЬ НЕ НЕСЕТ ОТВЕТСТВЕННОСТИ ЗА КАКОЙ-ЛИБО УЩЕРБ ПРИ НЕСОБЛЮДЕНИИ ПРАВИЛ
МОНТАЖА И ЭКСПЛУАТАЦИИ
D
АППАРАТ ДОЛЖЕН УСТАНАВЛИВАТЬСЯ СОГЛАСНО ДЕЙСТВУЮЩИМ ПРАВИЛАМ И ИСПОЛЬЗОВАТЬСЯ ТОЛЬКО В
ХОРОШО ПРВЕТРИВАЕМЫХ ПОМЕЩЕНИЯХ.
F
37M3202
C B
WEEE symbol: indicates that the appliance
H)
is subject to specific waste disposal regula-
tions.
GB
G
A
H
ENGLISH