Servicing; Recommendations For Servicing; Cleaning Instructions - Angelo Po 0N0TPE Bedienhandbuch

Keep the appliance at peak efficiency by
carrying out the scheduled servicing procedu-
res recommended by the constructor. Proper
servicing will allow the best performance, a
longer working life and constant maintenance
of safety requirements.
Important
Before carrying out any servicing procedure,
activate all the safety devices provided and
decide whether staff at work and those in the
vicinity should be informed.
In particular, turn off the electricity supply
using the circuit-breaker and prevent access
to all devices which might people's health and
safety at risk if activated.
Also make sure that during the maintenance
procedure, that the operator is always able
to check whether the plug is disconnected
from the power outlet.
Since the appliance is used for preparing foods
for human consumption, special care must be
paid to everything relating to hygiene, and the
appliance and the entire surrounding envi-
ronment must constantly be kept clean.
Important
GB
Before starting any cleaning operation,
always turn off the gas supply tap, cut off the
electricity supply using the master switch
and allow the appliance to cool.
The precautions which follow are also impor-
tant.
Caution - Warning
When using detergents, rubber gloves, pro-
tective mask and safety goggles must be
worn in accordance with the relevant safety
regulations.
– Clean all parts of the appliance with warm
water, food-approved detergents and non-
abrasive materials only.
3320120_ut_GB 3320120_ut_GB

SERVICING

RECOMMENDATIONS FOR SERVICING

CLEANING INSTRUCTIONS

- 10 - - 10 -
At the end of each session of use and whenever
necessary:
– Clean the plate.
– Clean the accessories.
– Clean the appliance and the surrounding envi-
ronment (see page 10).
– Check the air filter, located under the
equipment, and clean it if it is dirty or clogged
(see page 11).
Every 100 working hours have skilled, autho-
rised personnel carry out the following opera-
tions:
– Check that the safety thermostat is working
correctly.
– Check that the electrical system is in good
working order.
– Thoroughly clean all parts which come into
direct or indirect contact with foods and all
surrounding areas.
– After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
Caution - Warning
Never use products containing substances
harmful or hazardous for health (solvents,
petroleum spirits, etc.).
– Rinse surfaces with drinking water and dry.
– Pressurised water jets may only be used on
external parts.
– Take special care not to damage stainless steel
surfaces. In particular, avoid the use of corrosi-
ve products and do not use abrasive materials
or sharp tools.
– Remove food residues immediately before
they set.
– Remove the limescale deposits which may
form on some of the appliance's surfaces.
ENGLISH ENGLISH