Winkhaus blueMotion Montageanleitung Seite 192

Installation, Operating and
Maintenance Instructions
EN
Error / Display
n
10 x acoustic signal
for about 1 second
The locking / unlo-
cking has not taken
place properly, the
motor moves into
zero-position.
CAUTION! Locking
can still be
6
(partially) closed.
n
5 seconds long,
short acoustic
signal
(about 20 x)
No acknowledge-
ment signal is given.
Does not lock auto-
matically.
Always locks auto-
matically.
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion
Possible cause
Locking or unlo-
cking is too stiff and
sluggish, because
e.g.:
• lock has encoun-
tered an hindrance
• door is extremely
warped
• the latch has not
latched properly
• profile cylinder
without free
moving cam
• position of the
cam > ± 30°
• power outage
• power outage
• magnet out of
range
• Lock in day ser-
vice mode
• has been set to
day service mode
• door is not closed
all the way
• magnet is not set
properly
• power outage
• profile cylinder
without free
moving cam
• is set to night ser-
vice mode
88
Troubleshooting
Contact customer service!
Draw door towards you, open
manually via the key, press the
button for opening the door,
conduct a performance test.
Additionally:
• check keeps for damage
• check door settings (keeps,
airgap)
• adjust the keeps (change the
gaskit)
• check the profile cylinder
CAUTION! Warning signal 10 x
in sequence  Blocking.
• open / lock door manually by
using the key / handle
Notice: In the event of a power
outage, via the battery the
motor will drive to a defined
position once. There are no
other signals given to indicate
that the system is battery
operated.
• open / lock manually via the
key or handle
• check door settings
• change to night service
mode
• close the door properly or
set properly
• set magnet
• check power supply
• check cable transition
• check profile cylinder for
free moving cam
• change to day service mode
5044745