Wireless Receiver (Separate) - Winkhaus blueMotion Montageanleitung

Installation, Operating and
Maintenance Instructions
• The default setting of the jumper is 24 V.
• The wireless receiver can be adjusted from 24 V to 12 V via the jumper.
Notice: Check the proper position of the jumper before starting
operation!

3.6.2 Wireless receiver (separate)

Separate wireless receiver for additional applications, such as garage door
control units.
Figure 3.6.2-1: Installing the wireless receiver
Installation sequence
• Remove the housing cover.
• Fasten the housing with screws.
• Push in the rubber plug (see figure 3.6.2-1).
• Insert the circuit board of the receiver according to figure 3.6.2-2 and
connect it to the control of the other application (e.g. garage door control).
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion 55 5044745
EN
3