Cable Transition T-Ht Kü M1188 - Winkhaus blueMotion Montageanleitung

Installation, Operating and
Maintenance Instructions
3.3.2 Cable transition T-HT KÜ M1188
Installation sequence
• Cut on oblong hole in the door frame according to specifications (refer to
figures 3.3.2-3 / 3.3.2-4)
• Run the cable through the door frame
CAUTION! Leave some spare cable (loop) directly behind the
cable transition to allow for the spring to expand!
• insert and screw cable transition (with cable transition fitting piece and
radius shimming plate)
Notice: The cable transition fitting piece simplifies installation
in timber doors. It saves plodding with the chisel.
This cable transition is qualified for doors with 18 mm fixed
pivotal point and 180° opening. Do not bend the cable
transition and do not undershoot the bending radius of
Ø 25 mm.
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion 39 5044745
Figure 3.3.2-1: Cable
transition fitting piece
Figure 3.3.2-2: Radius
shimming plate
EN
3