Frame Power Supply (Optional) - Winkhaus blueMotion Montageanleitung

Installation, Operating and
Maintenance Instructions
EN

Frame power supply (optional)

2
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion
The Winkhaus frame power supply is a switching
power supply (single-phase, primary pulsed
installation current supply, high pulse load capa-
city, short-circuit proof, open-circuit proof, high
efficiency, thermal overload protection). The
power supply is suitable for mounting in the
frame, on the construction site only the principal
voltage (230 V AC) has to be made.
• 4 m cable for connection 230 V AC with cable
• 0.4 m cable with eyelet (M4) for earthing the
• 0.2 m cable with plug for connection with
• 4 m cable (6-wire) for external signal
T-NETZTEILRAHM. 24 V DC 1 A
(2 A / 2 S)
Caution! Cable for external signal at frame power supply is
current (24 V DC), do not connect external voltage!
Insulated in delivery state, always INSULATE in the event of a
reduction (e.g. adaptation to the installation situation).
DANGER! The door profile must be grounded properly (secure
the eyelet for earthing securely to the metal profile).
Use cable grommet at 230 V cable (2 x included)!
No external voltage on output for external signals.
end sleeves
door profile
cable transition frame part T-KÜ-T1 RT
KABEL 0,6M RNT
(potential-free contact - switching time min.
0.5 seconds) from external access control
systems including voltage supply (output)
26 5044745
5038589