Winkhaus blueMotion Montageanleitung Seite 160

Installation, Operating and
Maintenance Instructions
EN
3
• Put the cover back on the housing and lock and screw it down.
Figure 3.6.2-2: Installing the circuit board of the receiver
No.
8, 9
9, 10
11, 12
11, 13
14
15
• You can set the K4 relay as ON / OFF or as an impulse via the JP1 jumper
(see figure 3.6.2-3). The setting dependens on the control unit which is to be
triggered by the receiver.
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
Notice: Pay attention to the relevant installation instructions
for additional use!
Terminals circuit board of the receiver
NO relay K4 - non-operated contact is open, it closes by activating
per remote control
NC relay K4 - non-operated contact is closed, it opens by activating
per remote control
"12 V AC / DC"
"24 V AC / DC"
Antenna
Screen
blueMotion 56 5044745
No. Name
JP1 jumper
P1 button
K4 relay
red LED
green LED