Non Winkhaus Access Control System (Acs); Non Winkhaus Access Control System Acs General (Frame- And Sash Side); Non Winkhaus Access Control System Acs Fingerprint (Sash Side) - Winkhaus blueMotion Montageanleitung

Installation, Operating and
Maintenance Instructions
3.8

Non Winkhaus access control system (ACS)

3.8.1 Non Winkhaus access control system ACS general
(frame- and sash side)
If the blueMotion multipoint lock is used for others, as the aforementioned sys-
tems (such as transponder set, remote control), note the following points:
• We recommend the Winkhaus power supply T-HT NETZTEIL 24 V DC / 2,5 A
(Art.-No. 2126934) or the frame power supply T-NETZTEIL RAHMEN 24 V
DC 1 A (2 A / 2 S) (Art.-No. 5038589) to use.
• For details on the voltage supply see also chapter 2, power supply
• Ensure that the decontrol signal takes place over a potential-free contact
when using non-Winkhaus access control systems.
• If required use a coupling relay for realizing this.
3.8.2 Non Winkhaus access control system ACS
fingerprint (sash side)
Prerequisites for installation
• The applied access control system have to be installed into the door sash.
• With the specified cable transition set "T-SET KÜ-T1 FT INTEG-BM 3.5 + 1.5
M EST", it is possible to set additional access controls and opening signals
(potential-free signal: e.g. "Open" button, intercom , ...).
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion 61 5044745
.
EN
3