Winkhaus blueMotion Montageanleitung Seite 112

Installation, Operating and
Maintenance Instructions
EN
1
The locking systems are incorrectly used – that is used contrary to the terms
described above – in evident in particular, if:
• the instructions on the intended use are not being followed;
• the problem-free operation is hindered due to the installation of external
objects and / or objects that are not purpose-conformant in the opening
zone, the locking system or within the keeps;
• the locking system or the keep is manipulated in such a way that their design,
mode of operation or function is changed;
• the door is drilled through in the area of the lock housings or of the lock rod
once the lock has been installed;
• the dead bolt projection or other locking components are employed
contrary to their intended purpose, as a means to hold the door opened;
• the handle's pin is driven through the spindle with force;
• the lock components are installed improperly or are tampered with, e.g. by
painting over moveable parts such as the bolt or the latch;
• loads exceeding those of normal manual force are transmitted via the safety
key onto the lock system;
• perform a manual or mechanical locking or unlocking during the motor is
working;
• the handle is turned counterclockwise or if a force greater than 150 N is
exerted on the handle;
• the clearance between the door frame and sash is increased or decreased,
which would for instance result from readjusting the hinge plates or from
lowering the door;
• if auxiliary lifting tools or other tools are used to open or close the lock;
• the handle and key are used at the same time;
• the lock is opened / closed with objects not intended for that purpose;
• the size of the door opening deviates from the specifications prescribed.
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion 8 5044745