Maintenance And Repair; Cleaning And Care; Inspection - Bosch Rexroth HD 2 Montageanleitung

10 Maintenance and repair

High electrical voltage!
Risk of severe injury or death from electric shock.

Disconnect the relevant system component before performing any maintenance
or repair work.

Secure the system against being switched back on unintentionally.
High pneumatic pressure!
Risk of severe injury or death.

Switch off the compressed air supply to the relevant system component before
performing any maintenance or repair work.

Secure the system against being switched back on unintentionally.
Hot electric motor surfaces during operation!
Risk of burns from touching hot surfaces above 65 °C.

Install appropriate guards.

Let the unit cool down for at least 30 minutes before performing
maintenance and/or repair work.
• Only inspect and adjust continuous conveyors that are in motion or operation when
the safety guards are in place.
• Observe DIN EN ISO 13857 when you remove or replace safety guards and/or
bypass safety equipment.
• Test runs with open paneling should only be performed by a person with
appropriate knowledge and experience using tip switches, and if there is no
possibility of interference from other switching devices.

10.1 Cleaning and care

Failure of bearings
Applying grease-dissolving substances to the bearing points, e.g. during cleaning,
leads to bearing failure. There is a risk of damage to property, and the service life
may be reduced.

Keep degreasers or aggressive cleaning agents away from the bearings!

Only clean the product with a damp cloth.
Failure of the toothed belt
Applying grease-dissolving substances to the toothed belt, e.g. when cleaning, leads
to the failure of the toothed belt. There is a risk of damage to property.

Keep degreasers or corrosive cleaning agents away from the toothed belt!

Only clean the product with a damp cloth.

10.2 Inspection

Lift rotate unit
Check the pneumatic connections regularly for leaks.
Maintenance and repair
WARNING
CAUTION
NOTICE
3 842 358 735/2019-10, MIT: HD 2, Bosch Rexroth AG
31/38