Commissioning; Initial Commissioning - Bosch Rexroth HD 2 Montageanleitung

8 Commissioning

8.1 Initial commissioning

Sudden movements, falling workpiece pallets

Injuries caused by falling objects.

Make sure that the product has been installed properly by qualifi ed personnel
(see page 8) before starting it up.
Malfunctions due to incorrect assembly and commissioning
The product can get damaged, shortening its service life.

Commissioning requires basic mechanical, pneumatic and electrical knowledge.

The product should only be commissioned by qualifi ed personnel (see page 8).
• Before the initial commissioning or re-commissioning of a conveyor system,
carry out a risk assessment in accordance with DIN EN ISO 12100.
• According to EU Machinery Directive 2006/42/EC, you must equip the transfer
system with EMERGENCY STOP control devices.
• The surfaces of motors and gears can reach temperatures of over 65 °C under
certain load and operating conditions. In these cases, you must comply with the
respective applicable accident prevention regulations (UVV) by taking appropriate
constructive measures (safety guards) or by affi xing/displaying appropriate warning
signs!
• Make sure that all the electrical and pneumatic connections are either in use
or covered. Make sure that all bolted connections and plug-in connections are
properly seated. All relevant protective covers must be fi tted.
• Only inspect and adjust continuous conveyors that are in motion or operation when
the safety guards are in place.
• Observe DIN EN ISO 13857 when you remove or replace safety guards and/or
bypass safety equipment.
• Test runs with open paneling should only be performed by a person with
appropriate knowledge and experience using tip switches, and if there is no
possibility of interference from other switching devices.
• Only commission the product if all safety equipment has been installed in the
system and is ready for use.
• Only commission a product that has been completely installed.
CAUTION
NOTICE
3 842 358 735/2019-10, MIT: HD 2, Bosch Rexroth AG
Commissioning 23/38