Symbols Used - Bosch Rexroth HD 2 Montageanleitung

Table 5: Symbols used
1 2
SW13
M = 20Nm
D
SW5
M = 8Nm
D
PZ2 PH3
gleitmo 585 K Anti-Seize
GHD V 68
Loctite 243 Loctite 601
1 2 3
A B C X

7.4 Symbols used

Connection with T-bolt and fl ange nut.
Make sure the T-bolt is in the correct position when inserting it into the slot and
tightening it. The notch at the head of the screw indicates the orientation of the
T-bolt.
1 = T-bolt insertion position in the slot.
2 = T-bolt clamping position in the slot.
Tightening torque: 25 Nm
Hex wrench
SW = wrench size ... mm
M = required tightening torque ... Nm
D
Hex socket wrench
SW = wrench size ... mm
M = required tightening torque ... Nm
D
Screwdrivers for cross-head screws
PZ ... = Pozidriv screw drive, size ...
PH ... = Phillips screw drive, size ...
Lubricate/lubricate with specifi c grease lubricant:
• gleitmo 585 K: gleitmo 585 K, www.fuchs-lubritech.com
• Anti-Seize: Food Grade Anti-Seize/Loctite 8014, www.henkel.com
Lubricate/lubricate with specifi c mineral oil:
• GHD: Structovis GHD, www.klueber.com
• V 68: mineral oil with a viscosity of 68
Secure the screws with:
• Loctite 243: medium strength (detachable), www.loctite.de
• Loctite 601: high-strength screw retention (non-detachable), www.loctite.de
The marked parts are not required for the described assembly. Dispose of the
parts or use them for other purposes.
Graphical depiction of the assembly steps.
The numbers correspond to the sequence of assembly steps in accordance with
the instructions in the accompanying text.
Graphical depiction of the designation of components.
The letters denote the components mentioned in the accompanying text.
Detail view from a different direction,
for example, the back or the bottom side of the product.
3 842 358 735/2019-10, MIT: HD 2, Bosch Rexroth AG
Assembly 15/38