Securing The Heyner® Multifix Aero+ With The Three-Point Belt Of Your Car - Heyner MultiFix AERO Bedienanleitung

English
Now take the Top Tether (TT) and guide it under
the head rest along to the appropriate Top Tether
anchor point of the car.
This can be found in the
instruction manual of the car.
Click the Top Tether into place and pull thebelt tightly.
Please check once more, if the child car seat is securely
fi xed onto the seat.
Attention: If the Top Tether (TT) has been correctly fi xed,
a green marking appears on the safety button.
Precaution! Make sure you do not accidentally
use the luggage hooks instead of the Top Tether
anchoring point.
Only if the HEYNER® MultiFix AERO+ with the ISOFIX
anchors (IA)is properly installed in the car
the children's car seat can achieve optimal
safety for your child.
Look out for this symbol in your vehicle:
1.3.3 How to remove ISOFIX and Top
Tether
Make sure that the seat is not in lying
down.
31
Loosen the Top Tether (TT) by pres-
sing the release button
and remove it from the anchorage
point of the vehicle.
Place the Top Tether (TT) over the
child car seat.
Press the release buttons.
With an audible >> click <<
the ISOFIX anchoring is unlocked.
Now you can remove the child car seat.
1.4 Securing the
HEYNER® MultiFix AERO+
with the three-point belt
of your car
1.4.1 Requirements
The seat can be used on
all approved seats of your vehicle
fi tted with aThree-point belt. For
best protection,
use the child car seat seats preferably on the back seats.
The seat must NOT be placed in the middle rear seat as it
only has a lap belt!
1.4.2 Installation and mounting on
to the car seat
• Push the seat (ST) into the lying
position by pressing the positio-
ning handle (PG).
English
Press
32