Herunterladen Inhalt Inhalt Diese Seite drucken

Installation / Fixing With Isofix (Without Top Tether) And The Three-Point Belt Of The Car (Semi-Universal) - Heyner MultiFix AERO Bedienanleitung

9-36 kg 9 monate - 12 jahre
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
English
Caution: the safety bolt (SB)
must lock the seat (ST)
completely with the base (BT) again.
To remove the crotch strap,
slide the belt together with
the metal plate from the top
to the bottom of the seat.
Now you can completely remove
the 5-point harness system.
Store away the central harness belt (G5)
under the adjuster cover (F).
2.2 Installation / Fixing with ISOFIX
(WITHOUT Top Tether) and the
three-point belt
of the car (semi-universal)
The ISOFIX device is only permitted
as an additional fi xing
in G II and G III. You can attach the seat with ISOFIX (I)
to avoid that the seat slips. Please follow the points in
section 1.3.
ATTENTION: Please check in your vehicle hand book
which car seats are suitable and are approved.
Place your child in the HEYNER®MultiFix AERO+
child car seat. Open the red belt guide at the head rest and
put the diagonal belt of the vehicle through the shoulder
37
belt guide. Afterwards, relock it. In order to ensure an
optimum belt guide, the shoulder belt should run along
the middle of the shoulder.
Let the shoulder strap of the vehicle run through the belt
guide slot. The shoulder strap should run in the middle
of the shoulder to ensure an optimal belt path.
CAUTION: The belt must not be twisted. The head rest
must be properly adjusted according to your child.
To adjust the height of the headrest (A) to the size
of your child, pull the headrest from the front and move
the adjusting lever (H) upwards. Now you can adjust the
headrest (A) to the desired height. The distance between
the lower edge of the headrest and the shoulder of the
child should be two fi nger widths. Once you have reached
the correct height, release the adjusting lever (H) and the
headrest (A) snaps into the desired height.
Now run the lap belt (W) with the lock tongue (V) over
the armrests of the child car seat towards the three-
point belt buckle and secure the lock tongue (V) from the
three-point belt of the vehicle into
the three-point belt buckle with an audible << click >>.
IMPORTANT:
The diagonal belt should be centred over the child's
shoulder, the lap belt should run as low as possible over
the groin.
Make sure that the diagonal strap is straight and not too
close to the child's neck. All straps must be tight against
the child's body and
must not be twisted.
English
38

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis