Putting Out Of Operation; Maintenance And Cleaning; Electric Shock - Abicor Binzel TCS-Compact Betriebsanleitung

7 Operation
7 Operation
NOTE
• As the cleaning station TCS-Compact is integrated into a welding system, the operating instructions of
• Make sure that the TCS-Compact is operated with the delivered protective device only.
1 Switch on the robot control.
2 Start the welding process.
3 Stop the welding process.

8 Putting out of operation

NOTE
• As the cleaning station TCS-Compact is integrated into a welding system, putting out of operation
1 Switch off the robot control.

9 Maintenance and cleaning

Scheduled maintenance and cleaning is a prerequisite for a long life and a trouble-free operation.
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair work, the following instructions
must be adhered to:
• Switch off the power supply.
• Close off the compressed air supply.

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace the damaged parts.
NOTE
• The maintenance intervals given are standard values and refer to single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified and trained specialists.
• Always wear your personal protective clothing when performing maintenance and cleaning work.
The cleaning station TCS-Compact is virtually maintenance-free. However, it is necessary to regularly clean
and evaluate the mechanically stressed parts in order to maintain its value and to guarantee its full ability to
function.
EN - 28
the welding components, such as welding torch and robot control, must be observed during
operation.
depends on the robot control. Please make sure that the shutdown procedures for all components
integrated in the welding system are strictly observed.
DANGER
DANGER
TCS-Compact