Wire Cutting Device En - Abicor Binzel TCS-Compact Betriebsanleitung

6 Putting into operation
6.2.2 Wire cutting device
1
8
Countersunk screw M5x20
1
Protection plate
2
3 Welding torch
Wire cutting device
Fig. 13
1 For better access loosen protection plate and move it backwards
2 Move the welding torch to the cutting position
NOTE
• Observe the desired stick-out length.
3 Move the free wire end to the fixed cutter. (lower cutting edge)
4 As soon as you have programmed the desired cutting length, the protection plate must be moved forward
again. The gap between the fixed cutter and the protection plate should be < 4 mm.
EN - 18
2
Stick-out (SO) - free wire end
4
Guiding plate for wire clippings
5
6 Movable cutting plate
7
Fixed cutting plate
7
Container for wire clippings
8
TCS-Compact
3
4
5
6