Abicor Binzel TCS-Compact Betriebsanleitung Seite 60

11 Dismounting
10.3 Wire cutting device
Fault
No cutting function
Insufficient cutting capacity
Free wire end is bent
Troubleshooting wire cutter
Tab. 17
11 Dismounting
Dismounting may only be carried out by specialized personnel. Please make sure that the shutdown
procedures are strictly observed before the dismounting is started. Make sure to include also the
components integrated into the welding system.
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair work, the following instructions
must be adhered to:
• Switch off the power supply.
• Close off the compressed air supply.
NOTE
• Observe the information given in section 8 Putting out of operation on page EN-28.
12 Disposal
For the maintenance station TCS-Compact to be properly disposed of, it first must be dismounted. For
disposal, observe the local regulations, laws, provisions, standards and guidelines.
 See chapter 11 Dismounting on page EN-30
12.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works and are, thus,
almost infinitely recyclable. The plastic materials used are marked in preparation for sorting and separation
of the materials for later recycling.
EN - 30
Cause
• Compressed air-supply / hose connection
interrupted
• Directional valve Y3 does not switch
• Too low working pressure
• Rough-running slide
• Worn cutting edge
• The wire has no contact to the fixed jaws
• Counter support jammed
DANGER
Solution
• Check all supply lines leading to the cylinder
and the fittings
• Check signal output of robot control
• Replace directional valve Y3.
• Check the adjustment of the pressure regulator:
min. 5 bar/max. 8 bar
• Dismount movable parts, clean and lubricate
them
• Clean more often
• Change approach position P4
• Change the cutter
• Correct the approach position of the welding
torch
• Dismount movable parts, clean and oil them
• Tighten the mounting screws
TCS-Compact