Fastening The Cutting Prism En - Abicor Binzel TCS-Compact Betriebsanleitung

TCS-Compact
NOTE
• If the cutting plates reach their wear limit (the following are possible, poor cutting quality, jamming of
• Program a new cutting position in a new place in the area of the cutting plates.
6.2.3 Fastening the cutting prism
5
Clamping prism
1
ø
Mark for gas nozzle
2
Fig. 14 Fastening the prism
1 Mount the clamping prism (1) into the clamping device (5) from above.
NOTE
• Please observe that a clamping prism (1) is mounted which fits the gas nozzle diameter. You can find
 see Fig. 14 Fastening the prism on page EN-19, Pos. (2)
2 Fasten the clamping prism with the cylinder screw (3) (tightening torque 20Nm).
device, incomplete cut etc.), the cutting plates do not need to be exchanged at once.
1
Cylinder screw M8x20
3
Allen key, SW 6
4
the diameter of the prism on the prism.
6 Putting into operation
2
3
4
Clamping device gas nozzle
5
EN - 19