Setting Up The Compressed Air-Motor En - Abicor Binzel TCS-Compact Betriebsanleitung

6 Putting into operation
1 Position the torch with the gas nozzle (2) concentrically to the tool axis (milling cutter axis) over the
cleaning station (3).
2 Approach the clamping position. Make sure that the cylindrical part of the gas nozzle (2) lies evenly
against the clamping prism (1).
NOTE
• The clamping position in the direction of the milling cutter axis should be in the cylindrical part of the
6.3 Setting up the compressed air-motor
Cleaning station
1
2 Welding torch
Gas nozzle clamping device
3
Setting up the compressed air-motor
Fig. 18
NOTE
• Before you can set up the compressed air-motor in its final position, the welding torch has to be
 Fig. 17 Setting up the clamping position on page EN-21
• The motor stroke needs to be in the lower position (8) (stroke down).
 Fig. 18 Setting up the compressed air-motor on page EN-22
EN - 22
gas nozzle.
Please observe that the clamping position (5) can vary depending on the gas nozzle type.
1
9
Gas nozzle
4 6
5 Milling cutter 7
positioned in the cleaning station.
2 3
4
5
6
7
8
Clamping screws M6x45
Allen key SW6
TCS-Compact
Compressed air-motor
8
(stroke down)
Motor fastener
9