Electrical Connection En; Injection Unit En - Abicor Binzel TCS-Compact Betriebsanleitung

6 Putting into operation
6.1 Electrical connection
The cleaning station of the welding torch is connected to the power supply via an integrated plug
connection. The necessary control signals also well transmitted via this plug.
Electrical connection
Fig. 8
NOTE
• Ready-to-use control leads are available in lengths of 5m and 10m (optional).
• For electrical connection check device type NPN resp. PNP.
6.2 Injection unit
NOTE
• Before setting up, please check that the suitable gas nozzle seal is mounted. This depends on the gas
• Inflowing compressed air draws in the anti-spatter fluid and mixes it with the compressed air flow.
EN - 14
6
5
4
nozzle diameter used.
Recommendation: The period needed for a sufficient wetting of the gas nozzle / welding torch should
not exceed 2-3 sec.
Operating
1 PE
voltage
2 GND
7
3 24 VDC/200 mA
8
Input
4 Clamp closed /
9
wire cutter on (Y3) 24VDC/2,8W
5 Lift up (Y1) 24VDC/2,8W
1
6 Motor rotation (Y2) 24VDC/2,8W
2
3
Output
7 Lift down 24VDC/max.100mA
8 Clamp open
9 n.c.
TCS-Compact
24VDC/max.100mA