Adjusting The Anti-Spatter Fluid En - Abicor Binzel TCS-Compact Betriebsanleitung

6 Putting into operation
6.2.1 Adjusting the anti-spatter fluid
1
Injection
opening
9
8
Welding torch
1
Rubber gasket for gas nozzle
2
Gas nozzle
3
Fig. 11 Adjusting the anti-spatter fluid
NOTE
• Make sure that the welding torch / gas nozzle is placed concentrically over the injection unit.
1 Place the welding torch (1) over the injection opening.
2 Move the welding torch (1) slowly downwards (in the direction of the arrow). Hereby, the rubber gasket
is "opened".
The immersion depth of the welding torch is limited by the stroke of the injection unit.
3 Move the gas nozzle with the front side to the thrust ring.
Move the welding torch further down to activate the injector function.
NOTE
• Please observe the max. stroke of the injection unit (see Fig. 12 Stroke movement injection unit on
EN - 16
2
Deactivate injection impulse
max. 6 mm
Activate injection impulse
Thrust ring
4
Injection nozzle
5
Anti-spatter bottle (full)
6
page EN-17)
3 2 4
Drain bottle
7
Adjusting screw (volume control anti-spatter)
8
Cover
9
TCS-Compact
5
6
7