Mounting The Milling Cutter En - Abicor Binzel TCS-Compact Betriebsanleitung

6 Putting into operation
6.2.4 Mounting the milling cutter
2
6
7
6
5
Milling cutter
1
Wrench SW17
2
Wrench SW21
3
Mounting the milling cutter
Fig. 15
NOTE
• Only use tools with a suitable width across flats when changing the milling cutter. Motor protection
• Ensure that the bellows (5) is in the right position.
 see Fig. 16 Position bellows on page EN-21
1 Mount the motor protection cap (6).
2 Mount the milling cutter (1) onto the compressed air-motor (4).
3 Tighten the milling cutter (1) by means of the wrench SW17 (2) (minimum tightening torque 20Nm) and
hold with a wrench SW21 (3).
NOTE
• For a better mounting, the compressed air-motor should be in the lower clamping and stroke position.
EN - 20
Compressed-air motor
4
Bellows
5
cap (6) SW 21, milling cutter SW 17.
TCS-Compact
Motor protection cap
6
Motor output shaft
7
1
2
3
4