Height Adjustment En - Abicor Binzel TCS-Compact Betriebsanleitung

TCS-Compact
6.3.1 Height adjustment
4
5
9
Gas nozzle
4
Milling cutter
5
Height adjustment
Fig. 19
 see Fig. 18 Setting up the compressed air-motor on page EN-22
NOTE
• The device has to be depressurized during set-up.
1 Loosen the clamping screws M8x45 (6) using an Allen key (8) . Meanwhile, hold the
compressed air- motor (8).
2 Move the compressed air- motor (8) to the upper stroke position (Fig. A) (the compressed-air motor can
be moved into the upper stroke position manually).
3 Move the compressed air- motor (8) upwards in the fastener (9) until the front side of the
milling cutter (5) hits the front side of the gas nozzle (4). (Fig. B)
4 Fasten the clamping screws M8x45 (6) on the motor fastener (9) (minimum tightening torque 20 Nm).
lower stroke position upper stroke position
A
Clamping screws M8x45
6
Compressed-air motor
8
6 Putting into operation
B
8
Motor fastener
9
4
Stop
Milling cutter
5
EN - 23