Barbecue - Silvercrest SEGS 2300 A1 Bedienungsanleitung

For use as a tabletop barbecue, please
observe the assembly instructions in the fol-
lowing sections:
-

5.1 Barbecue

- 5.2 Support dish
- 5.4 Preparations before barbecuing
To convert the barbecue from a tabletop
barbecue into a free-standing bar-
becue, attach the legs to the support
dish 22:
- 5.3 Frame (freestanding barbecue)
To convert the barbecue from a free-
standing barbecue into a tabletop
barbecue, pull the legs out of the leg
mounts 31.
5.1 Barbecue
Lid
1. Place the handle 25 onto the lid 24.
The holes drilled in the lid and the han-
dle must match up.
2. Hold the handle 25 firmly in this posi-
tion and flip the lid 24 over.
10 GB
3. Place the upper heat reflector plate 26
into the lid 24 from the inside. Pay at-
tention to the drill holes here, too!
4. Screw the two screws 9 into the holes
until the handle 25 and upper heat re-
flector plate 26 are firmly attached.
5. Release the wingnut 33 from the ther-
mometer 32.
6. Place the thermometer 32 (with the mid-
dle of the scale pointing upwards) into the
hole in the lid 24. Screw the wing-
nut 33 tight from inside.
9