Silvercrest SEGS 2300 A1 Bedienungsanleitung Seite 12

DANGER! Risk of electric
shock due to moisture
Protect the device from moisture, water
drops and water splashes.
If liquid gets into the device, disconnect
the mains plug immediately. Have the
device checked before reusing.
Never touch the device with wet hands.
If the device falls into water, disconnect
the mains plug immediately. Only then
is it safe to remove the device.
DANGER! Risk of electric
shock
Only plug the mains plug into the wall
socket after the device has been com-
pletely assembled.
Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket with earthing contact whose volt-
age corresponds to the specifications on
the rating plate. The wall socket must
still be easily accessible after the device
is plugged in.
When using an extension cable or a
multiple socket, they must comply with
the applicable safety regulations and be
designed for the technical data of this
device.
Ensure that the power cable cannot be
damaged by sharp edges or hot spots.
Do not wrap the power cable around
the device.
The device is not fully disconnected from
the power supply, even after it is
switched off. In order to fully disconnect
it, pull out the mains plug.
When using the device, ensure that the
power cable cannot be trapped or
crushed.
When removing the mains plug from the
wall socket, always pull on the plug and
never the cable.
8
GB
Disconnect the mains plug from the wall
socket ...
... if there is a fault,
... when you leave the device unattend-
ed,
... immediately after each use,
... before assembling/disassembling
the device,
... before you clean the device and
... during thunderstorms.
In order to avoid any hazards, do not
make modifications to the device.
Do not use the device if there is visible
damage to the device or the power ca-
ble.
DANGER! Risk of fire
The device must only be set up on a sol-
id, level, dry and non-flammable sur-
face. This is intended to prevent it from
tipping, slipping or setting fire to the un-
derlying material and thus causing dam-
age.
The device must not be operated close
to flammable liquids or materials, or in
a potentially explosive environment.
Keep at a distance of at least 50 cm
from walls and other objects.
The power cable must not touch the hot
surfaces during operation.
DANGER! Risk of injury
through burning
The lid and the bottom part of the bar-
becue become very hot during opera-
tion. During operation, touch only the
handle, the control elements and the
support dish.
When using it as a freestanding barbe-
cue: set the device up in such a way
that no one will accidentally knock over
the device or touch the hot surfaces.
The device remains very hot after it is
switched off, and must not be touched.
Only transport the device when it has
cooled down.