Operating modes and configuration
6.8
Selecting the desired temperature display
You can adjust the temperature to be displayed. You can
also define whether the humidity value shall be displayed
or not.
•
Press and hold down the control wheel (E) to
open the configuration menu.
•
Select the
wheel and confirm by pressing the control wheel
briefly.
•
Turn the control wheel and select
-
-
-
6.9
Configuring the floor heating actuator
You can use this menu item for configuring your
Homematic IP Floor Heating Actuator.
Press and hold down the control wheel (E) to
•
open the configuration menu.
•
Select the
wheel and confirm by pressing the control wheel
briefly.
•
If the wall thermostat is connected to more than
one floor heating actuator, please select the
required floor heating using the control wheel.
•
Please define if you want to configure the
76
"ACT" to display the actual temperature,
"SEt" to display the setpoint temperature,
"ACtH" for alternating between the actual
temperature
confirm by pressing the control wheel briefly.
symbol by turning the control
and
humidity
symbol by turning the control
display
and