Automatic Mode; Manual Operation - HomeMatic IP HmIP-WTH-2 Montage- Und Bedienungsanleitung

Operating modes and configuration
6.1

Automatic mode

In automatic mode, the temperature is controlled in
accordance with the set week profile (see „6.5.3 Week
profile" on page 73). Manual changes that are set via
the control wheel (E) are activated until the next point
at which the profile changes. Afterwards, the defined
heating profile will be activated again. To activate the
automatic mode, please proceed as follows:
Press and hold down the control wheel (E) to
•
open the configuration menu.
• Select the
wheel and confirm by pressing the control wheel
briefly.
6.2

Manual operation

In manual mode, the temperature is controlled in
accordance with the current temperature set via the
control wheel (E). The temperature remains activated
until the next manual change. To activate the manual
mode, please proceed as follows:
Press and hold down the control wheel (E) to
•
open the configuration menu.
• Select the
wheel and confirm by pressing the control wheel
briefly.
• Turn the control wheel to set the desired
temperature.
66
symbol by turning the control
symbol by turning the control