Restore Factory Settings - HomeMatic IP HmIP-WTH-2 Montage- Und Bedienungsanleitung

Restore factory settings

1x long red
lighting
6x long red
flashing
1x orange
and 1 x green
lighting (after
inserting
batteries)
10 Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the wall thermostat,
please proceed as follows:
• To remove the electronic unit (B) from the frame,
take hold of the sides of the electronic unit and
pull it out (see figure 6).
• Remove a battery.
84
Transmission
failed or duty
cycle limit is
reached
Device
defective
Test display
Please try again
(see sec. „9.2
Command not
confirmed" on
page 81 or „9.3
Duty cycle" on
page 81).
Please see your
app for error
message or
contact your
retailer.
After the test
display
has stopped,
you can continue.