Maintenance And Cleaning - HomeMatic IP HmIP-WTH-2 Montage- Und Bedienungsanleitung

• Insert the battery ensuring that the polarity is
correct (see figure 7) and press and hold down
the system button (D) for 4 seconds at the same
time, until the LED will quickly start flashing
orange (see figure 8).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the status LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart.
11

Maintenance and cleaning

The device does not require you to carry out any
maintenance other than replacing the battery
when necessary. Enlist the help of an expert to
carry out any maintenance or repairs.
Clean the device using a soft, lint-free cloth that is clean
and dry. You may dampen the cloth a little with lukewarm
water in order to remove more stubborn marks. Do not use
any detergents containing solvents, as they could corrode
the plastic housing and label.
Maintenance and cleaning
85