Teaching-In To The Homematic Ip Access Point - HomeMatic IP HmIP-WTH-2 Montage- Und Bedienungsanleitung

Start-up
orange. For further information, please refer to
the user manual of the floor heating actuator.
To remove the electronic unit (B) of the wall
•
thermostat from the frame, take hold of the sides
of the electronic unit and pull it out (see figure 6).
Turn over the electronic unit (B).
•
• Remove the insulation strip from the battery
compartment of the wall thermostat.
Press and hold down the system button (D) of the
•
wall thermostat for at least 4 seconds to activate
the pairing mode. The device LED flashes orange.
The device LED (D) lights up green to indicate that
teaching-in has been successful.
If pairing failed, the device LED (D) lights up red. Please
try again.
5.1.2

Teaching-in to the Homematic IP Access Point

First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the
operating manual of the Access Point.
To teach-in your wall thermostat to the Access Point,
please proceed as follows:
• Open the Homematic IP app on your smartphone.
• Select the menu item "Teach-in device".
58