HomeMatic IP HmIP-WTH-2 Montage- Und Bedienungsanleitung Seite 59

To remove the electronic unit (B) from the frame,
•
take hold of the sides of the electronic unit and
pull it out (see figure 6).
Turn over the electronic unit (B).
•
• Remove the insulation strip from the battery
compartment of the wall thermostat.
• Teach-in mode remains activated for 3 minutes.
You can manually start the teach-in mode for
another 3 minutes by pressing the system button
(D) briefly (see figure 8).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of
the device number (SGTIN) in your app or scan
the QR code. Therefore, please see the sticker
supplied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED lights up
green. The device is now ready for use.
• If the LED lights up red, please try again.
• Select the desired solution for your device.
• Allocate the device to a room and give the device
a name.
Start-up
59