Pairing With The Homematic Ip Floor Heating Actuator - HomeMatic IP HmIP-WTH-2 Montage- Und Bedienungsanleitung

enable it to communicate with other devices, you must
teach it in first.
You can either pair the wall thermostat directly with the
Homematic IP Floor Heating Actuator or teach it in to the
Homematic IP Access Point. After pairing, configuration
has to be done directly on the device. After teaching-
in to the Access Point, configuration is done via the
Homematic IP app.
5.1.1 Pairing with the Homematic IP Floor Heating
Actuator
Please make sure you maintain a distance of at
least 50 cm between the devices.
You can cancel the pairing procedure by briefly
pressing the system button (D) again. This will be
indicated by the device LED lighting up red.
If no teach-in operations are carried out, teach-in
mode is exited automatically after 30 seconds.
If you want to pair the wall thermostat with a Homematic IP
Floor Heating Actuator, the pairing mode of both devices
has to be activated first. To do this, proceed as follows:
• Select the required channel of the floor heating
actuator and activate the pairing mode using a
long button press. The device LED starts to flash
Start-up
57