Operation - HomeMatic IP HmIP-WTH-2 Montage- Und Bedienungsanleitung

Operation

7 Operation
After configuration, simple operations are available
directly on the device.
If the wall thermostat is in standby mode, please
press the control wheel (E) once before operation
to activate the device.
•
the right or to the left to manually change the
temperature. In automatic mode, the manually
set temperature will remain the same until
the next point at which the profile changes.
Afterwards, the defined heating profile will be
activated again. During manual operation, the
temperature remains activated until the next
manual change.
• Boost function for Homematic IP Radiator
Thermostats: Press the control wheel (E)
the wall thermostat briefly to activate the boost
function for heating up the radiator quickly and
briefly by opening the valve. There will be a
pleasant room temperature right away because
of the radiated heat.
78
Temperature: Turn the control wheel (E) to
of