Date And Time; Offset Temperature - HomeMatic IP HmIP-WTH-2 Montage- Und Bedienungsanleitung

6.6

Date and time

To set the date and time, please proceed as follows:
Press and hold down the control wheel (E) to
•
open the configuration menu.
• Select the
and confirm by pressing the control wheel briefly.
• Set the year, month, day and hour by turning
the control wheel and confirm by pressing the
control wheel briefly.
6.7

Offset temperature

As the temperature is measured on the wall thermostat,
the temperature distribution can vary throughout a room.
To adjust this, a temperature offset of ±3.5 °C can be set.
If a nominal temperature of e.g. 20 °C is set but the room
presents with only 18 °C, an offset of -2.0 °C needs to
be set. An offset temperature of 0.0° is set in the factory
settings. To adjust the offset temperature, please proceed
as follows:
Press and hold down the control wheel (E) to
•
open the configuration menu.
• Select the
wheel and confirm by pressing the control wheel
briefly.
• Turn the control wheel until the desired
temperature appears (±3.5 °C maximum).
• Confirm by pressing the control wheel briefly.
Operating modes and configuration
symbol by turning the control wheel
symbol by turning the control
75