Communication Test - HomeMatic IP HmIP-WTH-2 Montage- Und Bedienungsanleitung

device parameters ("UnP1/UnP2") or the channel
parameters ("ChAn").
• You can individually adjust the line-up time/
follow-up time, eco temperatures, intervals etc.
For further information regarding the configuration
options, please refer to the user manual of the floor
heating actuator.
6.10

Communication test

You can
Homematic IP Wall Thermostat and the Homematic
IP Floor Heating Actuator. During this test, the wall
thermostat transmits a switching command to the floor
heating actuator. Depending on the current status of the
actuator, the device is switched on or off for confirmation
after receiving the command.
Press and hold down the control wheel (E) to
•
open the configuration menu.
• Select the
and confirm by pressing the control wheel briefly.
check the
symbol by turning the control wheel
Operating modes and configuration
connection between your
77