Operating Modes And Configuration; Automatic Mode - HomeMatic IP HmIP-WTH-1 Installations- Und Bedienungsanleitung

Operating modes and configuration

GIRA
merten
JUNG
6 Operating modes and configuration
After pairing and mounting the device, you can individually adjust the
settings to your personal needs via the configuration menu. To do this,
proceed as follows:
• Press and hold down the control wheel (E) to open the configu-
ration menu.
• Select the desired symbol by turning the control wheel and
pressing it briefly if you want to adjust the settings of the follow-
ing menu items.
Press and hold down the control wheel to get back to the previous
level.
The menu automatically closes without applying changes if there is
no operation for more than 1 minute.
6.1
6.2
6.3
06:10
6.1

Automatic mode

In automatic mode, the temperature is controlled in accordance with
the set week profile (see see „6.6.1 Week profile" on page 40). Man-
ual changes that are set via the control wheel (E) are activated until the
next point at which the profile changes. Afterwards, the defined heating
schedule will be activated again. To activate the automatic mode, please
proceed as follows:
38
System 55, Standard 55, E2, E22, Event, Esprit
1-M, Atelier-M, M-Smart, M-Arc, M-Star, M-Plan
A 500, AS 500, A plus, A creation
Automatic mode
Manual operation
Selecting the desired temperature display
Communication test