Restarting; Inspection And Maintenance - Optimum OPTIdrill B13 basic Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
5.1.2

Restarting

Before restarting, run a safety check.
WARNING!
Before starting the machine you must be sure that

no dangers generated for persons,

the machine is not damaged.
5.2

Inspection and maintenance

The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Interval Where?
Start of work
and after each
maintenance
or repair work
weekly
Every month
Every 6
months
Every 6
months
GB B13 basic | B14 basic | B16 basic
Page 54
®
What? How?

"Safety check" on page 39

Check if the attachment screws for the V-belt tension on the
left and right side of the drilling head are well fastened.

Check if the V-belts are well tightened. Checking the tension
of V-belts,

Lubricate the drill column regularly with commercial oil.

Lubricate the toothed rod regularly with commercial grease
(e.g. friction bearing grease).

Check whether the V-belts have become porous and worn.
Img.5-1: V-belt housing

Check the electrical equipment / parts of the bench drill.
Translation of the original instructions

"Speed variation" on page 50.
V-belt
Version 1.0 dated 2019-01-08