During Work; Maintenance; Safety; Preparation - Optimum OPTIdrill B13 basic Betriebsanleitung

4.8

During work

The spindle sleeve feed is done via the star grip. Make sure that the feed is constant and not
too fast. The spindle sleeve is returned to its initial position by the return spring.
WARNING!
Seizing of clothes and / or hair.

Make sure to wear well-fitting work during drilling work.

Do not use gloves.

If necessary, use a hairnet.
CAUTION!
Risk of impact by the spindle sleeve lever.
Do not release the lever when resetting the drilling sleeve. Shock hazard due to energy
stored in the return spring of the quill.
INFORMATION
The smaller the bit the more easily it may break.
In the case of deep drilling, remove the bit from time to time to remove filings from the drill. Add
a few drops of oil to reduce friction and prolong the service life of the bit.
5

Maintenance

In this chapter you will find important information about

Inspection,

Maintenance and

Repair.
ATTENTION!

Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

long service life of the machine and

the quality of the products which you manufacture.
5.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:

extremely serious injuries to those working on the drilling machine and

damage to the machine.
Only qualified personnel should carry out maintenance and repair work on the machine.
5.1.1

Preparation

WARNING!
Only work on the drilling machine if it has been disconnected from the power supply.
Version 1.0 dated 2019-01-08 Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
B13 basic | B14 basic | B16 basic
®
GB
Page 53