1.15.1 Disconnecting And Securing The Bench Drill; Using Lifting Equipment; 1.16.1 Mechanical Maintenance; Accident Report - Optimum OPTIdrill B13 basic Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y

1.15.1 Disconnecting and securing the bench drill

Disconnect the mains plug before starting maintenance and repairs.
All machine parts as well as all dangerous voltages are switched off. Excepted are only the
positions which are marked with the adjoining pictogram.
Attach a warning sign to the machine.
1.16

Using lifting equipment

WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death.
Check that the lifting and load suspension gear

they have sufficient load carrying,

and that it is in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other supervisory authorities applicable to your company.
Fasten the loads carefully. Never walk under suspended loads!

1.16.1 Mechanical maintenance

Remove or install protection safety devices before starting or after completing any mainte-
nance work; this include:

covers,

safety instructions and warning signs,

grounding cables.
If you remove protection or safety devices, refit them immediately after completing the work.
Check that they are working properly!
1.17

Accident report

Inform your supervisors and Optimum Maschinen Germany GmbH immediately in the event of
accidents, possible sources of danger and any actions which almost led to an accident (near
misses).
There are many possible causes for "near misses".
The sooner they are notified, the quicker the causes can be eliminated.
1.18

Electronics

Have the machine and/or the electrical equipment checked regularly, at least every six months.
Immediately eliminate all defects such as loose connections, defective wires, etc.
A second person must be present during work on live components to disconnect the power in
the event of an emergency.
Disconnect the bench drill immediately if there is a malfunction in the power supply!
GB B13 basic | B14 basic | B16 basic
Page 42
®
Translation of the original instructions Version 1.0 dated 2019-01-08