Maintenance Schedule; Handling And Transport; Dismantling And Disposal - Comet CRRC 50 ECO L Betriebsanleitung

In machines fitted with a combustion engine, remember to also carry out the special maintenance jobs
described in the engine manual.

MAINTENANCE SCHEDULE

Every 300 hours.
Every 500 hours.
At the end of the season or once a year.
(*) Checks must be more frequent if liquids are used with abrasive particles in suspension.
(**) The oil must be changed whenever the diaphragm is changed.
(***) For motor pumps fitted with MC 8 and MC 18 this is not necessary; for MC 20/20 and MC 25 it is done
when changing the pump oil.
(****) If very aggressive chemical products are used, the diaphragms are best changed whatever their condition.
CAUTION
• The data shown on the chart are approximate. More frequent jobs may be necessary in case of particularly
heavy-duty use.
WARNING
• Carry out the steps described in the
• When the machine has to be transported, remember to anchor it firmly to the transport vehicle (using
ropes or other suitable methods) and empty the tank.
• Take a firm hold of the handle (7) to avoid that knocks and bumps caused by unevenness of the ground
make you lose your grip. Bear this in mind especially with a full tank and wet ground.
• The machine is to be moved around only using the gripping points of the handle (7).
• Do not move the machine on gradients greater than 2% and when the ground is very wet.
WARNING
• Before scrapping the machine, make it unusable, for example by cutting the power lead and render
harmless those parts that could be hazardous for children playing with the machine. Also remember to
empty the tank completely.
Only qualified persons must be allowed to dismantle the machine and this operation must be performed in
compliance with the laws applicable in the country where it has been installed (also refer to the contents of
the
"IDENTIFICATION AND CAUTION PLATES"
WARNINGS ABOUT THE MATERIALS (REACH)
WARNING
Up-to-date information is available at: www.comet-spa.com/it/company/legal/
• Check the pump suction/delivery valves and the control unit
regulation valve. (*)
• Oil change (**)
• Reduction gear oil change (***).
• Check and if necessary change the diaphragms (****)
• Check the tightness of the motor pump screws.
• Check the safety devices.

HANDLING AND TRANSPORT

paragraph before handling or transporting the machine.
"STOP"

DISMANTLING AND DISPOSAL

paragraph).
JOB
EN
41