Comet CRRC 50 ECO L Betriebsanleitung Seite 33

- spraying of water not for food use.
• The machine is not intended for spraying:
- aqueous solutions with density and viscosity above that of water;
- solutions of chemical products the compatibility of which with the materials making up the machine
itself is not known;
- seawater or water with high salt concentration;
- fuels and lubricants of all kinds and types;
- inflammable liquids or liquefied gases;
- edible liquids;
- solvents and thinners of all kinds and types;
- paints of all kinds and types;
- liquids with temperatures above 40 °C or below 5 °C;
- liquids containing granules or solid parts in suspension.
• The machine must not be used to wash: people, animals, energized electrical apparatus, delicate objects
or the machine itself.
• The accessories (standard and optional) used with the machine must be of the type approved by the
Manufacturer.
• The machine is not suitable for being used:
- in environments with special conditions such as, for example, corrosive or explosive atmospheres;
- in closed environments if it is equipped with a combustion engine.
• For use on board vehicles, ships or planes, contact the Manufacturer's Technical After-Sales Service,
inasmuch as additional requirements may be necessary.
All other uses are to be deemed incorrect.
The Manufacturer disclaims all liability for any damage deriving from incorrect or erroneous uses.
WARNING
• Also comply with the preliminary operations given in the manual of the combustion engine if
mounted on the machine.
• Make sure all deliveries are off or connected to accessories that have been turned off (e.g., tap (35) or
lance (13) in position).
"OFF"
• Make sure all the hooks (34) on the control unit are correctly engaged. Special attention should be paid
to those control units which are fastened to the pump by means of a hook.
• Check the tightness of the clamps connecting the pipes to their fittings.
• Make sure that the moving parts of the machine are suitably protected and that they are not accessible
to unauthorised persons.
• Do not use the machine in the event of:
- the supply cable or other important parts such as the high-pressure pipes, the lance and the safety
devices being damaged;
- it tipping over or has suffered heavy knocks;
- evident oil leaks;
- evident leaks of pumped liquid.
In such cases, have the machine checked by a
• Never ever exceed the max inflation pressure of the accumulator (41) (when fitted). This is shown on the
table below.
• Have a
SKILLED TECHNICIAN
• Wear clothing and personal protective equipment able to provide adequate protection from any high-
pressure jets and chemical products used.
• Put a sheet in the bag (44) giving information about the chemical product being used. Update the
information each time a different chemical is used. Always check that the information is legible.
a) Check that the condition of the plants or cultivations is such to justify treatment.
b) Carry out the preliminary activities indicated in the manual of any combustion engine with which the
machine is fitted. In particular remember to fill with fuel and check the level of engine oil.
PRELIMINARY ACTIVITIES
SKILLED TECHNICIAN
perform the inspections required by special maintenance.
.
EN
33