Standard Equipment; Optional Accessories; Intended Use - Comet CRRC 50 ECO L Betriebsanleitung

Karren und schubkarren

Inhaltsverzeichnis

Verfügbare Sprachen

unloader/regulation valve to alter the setting: only operate on this by means of the knob (29).

b) Thermal or ampere cut-out protection device.

This device stops the operation of the machine equipped with electric motor in the event of overheating of

the electric motor or excessive power absorption, respectively.

If one of these trips, proceed as follows:

• remove the plug from the power socket;

• release any residual pressure in the high-pressure circuit, keeping the lever (26) of the lance (13) pressed

for a few seconds;

• wait 10÷15 minutes for the motor pump to cool down;

• make sure the instructions have been followed in the paragraph

POWER SUPPLY" ,

• fit the plug back in the socket and repeat the start procedure.

WARNING

• In case the thermal or ampere cut-out protection devices trip frequently, do not use the machine without

first having it checked by a

Make certain that the product purchased consists of the following elements:

• barrow/trolley with the motor pump chosen;

• hose reel (if this option has been chosen);

• lever lance with standard nozzle (1.5 mm Ø);

• manual of the combustion engine, if opted for;

• manual of the barrow/trolley;

• the declaration of conformity;

• the warranty certificate.

If there are any problems contact the Manufacturer or a

WARNING

• Inadequate optional accessories jeopardise machine operation and could make it dangerous and/or

harmful with regard to the environment. Always use only optional original accessories recommended

by the Manufacturer.

• As regards to the general recommendations, safety warnings, assembly and maintenance of the optional

accessories it is necessary to refer to the documentation given with them.

You can add the following range of accessories to the machine's standard ones:

• hose reel (various models according to the type of machine);

• different types of lance;

• different types of nozzle holder heads;

• nozzles of various dimensions.

Contact the Dealer for more information.

WARNING

• The machine is intended exclusively for the following uses:

- spraying and protective treatments of cultivations in gardens, greenhouses, meadows and cultivations

of a limited size;

- spraying of disinfectants and/or sanitizing products;

- spraying of detergents and colours in aqueous solutions;

with special reference to any extension used;

SKILLED TECHNICIAN