Symbols; Parked Position; Safety Systems - Bosch MUM5X-Serie Gebrauchsanleitung

Requirements
¡ The mains plug is not inserted.
¡ The swivel arm is open.
¡ The professional beating whisk is
inserted.
¡ The bowl has been inserted.
Hold the beating whisk at the bot-
1.
tom with one hand and release the
lock nut clockwise using a spanner
wrench.
→ Fig.
4
To change the distance, turn the
2.
tool.
→ Fig.
5
Observe the values in the table:
Setting
Optimum setting
One turn clockwise
One turn anticlock-
wise
Press the release button and push
3.
the swivel arm down until it en-
gages.
Check the setting.
4.
Press the release button and raise
5.
the swivel arm until it engages.
Hold the beating whisk at the bot-
6.
tom with one hand and tighten the
lock nut anticlockwise using a
spanner wrench.

Symbols

You can find an overview of the sym-
bols used on your appliance here.
Symbol Description
Marking on the protective cover
for drive 2.
Attachment marking on the pro-
tective cover for drive 3.
Position marking on drive 3.
Distance
3 mm
1 mm more
1 mm less
Familiarising yourself with your appliance en

Parked position

Your appliance is equipped with an
automatic parked position.
After the appliance has switched off,
the drives will continue moving for a
few seconds until the correct parked
position is reached.
Note: The swivel arm will only open
or close with the inserted tool when
the drive is located in the correct
parked position.
The following causes result in an
incorrect parked position:
¡ The power supply was interrupted
during processing.
¡ A safety system terminated pro-
cessing.
¡ During processing the swivel arm
disengaged or the release button
for the swivel arm was pressed.
Tip: You can easily adjust an incor-
rect parking position yourself.
→ "Troubleshooting", Page 50

Safety systems

You can find an overview of your ap-
pliance's safety systems here.
Start lock-out
Start lock-out prevents your appli-
ance from being switched on acci-
dentally.
The appliance can only be switched on
and operated if
¡ the swivel arm is engaged in posi-
tion 1 and the bowl or an access-
ory is inserted, e.g. Ice maker.
¡ the swivel arm is engaged in posi-
tion 3 and the protective cover or
an accessory is fitted on drive 3.
Restart lock-out
Restart lock-out prevents your appli-
ance from automatically restarting
processing after a power failure.
41